Showing results for 
Search instead for 
Do you mean 

Vista SP1 with ACT v9.0.1.162

New Member
Posts: 2
Country: USA

Vista SP1 with ACT v9.0.1.162

Trying to install ACT Standard from CD 04361, v9.0.1.162 on my Vista SP1 computer.

I get two errors during install, (program not responding dialog boxes) but installation completes successfully.

At this point ACT will not load. A computer reboot take an extra minute now & I get the same "not responding" dialogs during reboot.

I then tried to install the Vista Hotfix, ACT!905571, but it refuses to run based on my .162 version.


Is there any solution other than overpaying just to move to v10?





Platinum Elite Contributor
Posts: 14,580
Country: Australia

Re: Vista SP1 with ACT v9.0.1.162

"Program Not responding" is not an error message. It means the program is busy doing something.


Microsoft made a lot of changes in Vista and again in SP! that makes older products not run well. Upgrading to 10 is probably the smartest ways.


Or you could try installing in selective startup mode