12-09-2009 12:05 PM
When I print labels within ACT, I choose Avery Template 5160. However, the addresses dont align properly when printed out! The first line of the contact name gets cut off the label as I go down the page of address labels. The addresses don't align properly to the size label I have.
I didnt change anything on the template, but used one right from the template list.Is there something else I should do? I can't see why I would have to modify a pre-existing template. Can anyone suggest what to do? It's as if I just need a blank line above the contact names. Thank you.
12-09-2009 07:50 PM
12-16-2009 09:32 AM
Hi, Thanks for your reply. I am using genuine Avery Brand labels; product 5160. When I use a template from Avery's website with Word 2003, hp printers, all the addresses are centered perfectly! However, when I use ACT's template for Avery's labels (5160-5260-5560) with a hp 6122 printer, the names are cut off by the end of the label sheet. When I use ACT and a HP 5650, the same result with slightly less of the letters getting cut off. It's as if the addresses are not centered, or have no top margin.
I wouldn't expect to need to edit the preloaded templates in ACT. When I go to print, and view the edit page, the Avery properties are there. I dont think I ever changed the margins but the labels are definately not centered when I print them. I am wondering if I changed them in error at some point?
Would anyone be so kind to look in the ACT print labels section for Avery 5160 under edit (report Designer) to see the properties match what I have below?
Thank you very much. Judy
Font Arial, 9pt
Picture Alignment Center Middle
Show Picture AllPages
Maximum Pages 0
Margin Bottom 0.25
Margin Left 0.3
Margin Right 0.3
12-17-2009 11:28 AM
Most of the properties you listed relate to horizontal placement. The most important one related to vertical placement you didn't list which is top margin which should be 0.5 inches. The other critical property is the actual label height. To find that, click on the bar name Detail and check the height in the properties panel, that should be 1.0 inches. If those two check and you still have problems, the trouble has to be with the printer driver or the feed mechanism of the printer. I ran a sheet of labels on my system with the default 5160 label and the sheet printed correct without the problem you describe.
As a workaround if the height values check out, try increasing the top margin to 0.55 inches and the label height to 1.01 inches.
01-10-2018 11:56 AM
For the Record this does appear in the Avery Web site under Avery > Template Support > How do I print my project with Avery Design & Print so it aligns correctly?
Once your design is complete, click Preview & Print. Then click Print it Yourself, followed by Print Now to generate a PDF for printing.
Google Chrome is the preferred browser because you can easily open your file and it print accurately from there. Use Google Chrome!
If using a different browser, please follow the extra steps below for printing.
1. Deselect Fit to Page or Fit in your printer dialog. If these options remained checked, your project will shrink and not print accurately.
2. Go to your Printer Settings and select your printer. Go to the Preferences or Properties tab and set the material type to "labels" or "heavyweight" or "cardstock", depending on your product. If you don't see these options, you may need to click Print Using System Dialog. If you have questions about your printer settings, visit your printer manufacturer’s website for directions.
3. Use the manual feed in you printer tray for the best alignment results.