05-12-2014 08:05 AM
ACT Premium 2011/Outlook 2007/Windows 7/shared database on network drive
2 of 5 computers on shared database receiving the error message "The ACT! address book service is not configued correctly or the configured database "xxx" is locked. Do you want to configure it now?". Have tried several things, none of which worked:
1) Clicked yes, to add the database. The named database is already populated in the window, so we click "close", get the message changes will not take place until restarting Outlook. Works fine until the next day after logging back in. Same initial message appears.
2) Clicked no. Went into ACT - Tools - Preferences - Email tab. Same thing as above with regards to setting up the address book.
3) Followed these steps from a previous post:
- There should be 3 folders numbered 1 to 3. Make the changes to EACH folder:
- Make the "padFile" information blank
- Make the "Password" entry reflect the following: 4F4367F5F42DC7E280D133240E765ED3
- Make the "User" entry blank
Nothing works. We still get the same error message every time the 2 users open ACT after a logoff.
05-26-2014 11:16 PM
I am having a similar problem and its driving me NUTS.
I'll configure the ACT address book, do a couple of outlook task and then all of a sudden it sends an error message about the address book not being configure. so off I go again, check the add-in in outlook, restart, configure, open, couple of emails and then whammy, Address book not available
Please can someone help
05-26-2014 11:20 PM
to be more specific, even when just trying to open an email it says
Unable to perform the requested action. There are no ACT! address books setup at this time.
actually, it doesn't say GRRRRRRR, that was me.
05-27-2014 06:51 AM
I solved my issue. Since you are having a few more issues than I was, not sure if this will help, but....
The PAD file for the ACT database was located on our company network drive. I copied it onto the C: drive and went into Tools - Preferences in ACT and went into the Emai tab. From there, I setup the email to look for the PAD file on the C: drive, not the network drive. It's been fine since.
Hope you figure it out,